\n"); print (" \n"); print (" \n"); print (" \n"); print (" \n"); print (" \n"); print (" \n"); print (" \n"); print (" \n"); print ("
\n"); print (" \n"); print (" \n"); print ("
\n"); print (" \n"); print ("
\n"); print (" \n"); print ("
\n"); print (" \n"); print ("\n"); print (""); print (""); print (""); ?>
 






 

Instrumentation
Electronic Descaling

Cal-Ban™ is a revolutionary new device that treats water to prevent and remove hard scale

Cal-Ban™ is manufactured by Watersol Inc. in Calgary, Alberta, Canada. After years of development and testing, it is demonstrating its effectiveness in the prevention and removal of calcite, magnesium and barium sulfate scales. Check the following benefits.

Cal-Ban™ can be used in any place scaling is a problem: cooling towers, boilers/steam generators, heat exchangers and hot water systems to name a few and is equally effective with steel, copper or PVC plastic pipe. No plumbing or pipefitting required.

Minimum Flow Requirements

Nominal Pipe Diameter
Minimum Flow Required
Inches
US GPM
IMP. GPM
Liters/Minute
2
10
8
40
3
30
25
100
4
50
40
180
6
110
90
410
8
195
160
730
10
310
260
1,170
12
440
370
1,670

 

TECHNICAL DATA

  • Power requirements:
    110 volt, 60 Hz, 1 Ph.
  • Regulatory approvals:
    CSA inspected and labeled for general purpose.
    CSA inspected and labeled for Class 1, Division II explosive atmospheres.
  • Enclosure:
    Type 4, 4x, 12. Weather proof+
  • Installation requirements:
    Approximately 3 feet (1 M) clean bare pipe free of bends, fittings and valves.

Cal-Ban™ industrial models can be used on pipe sizes of 2” (50 mm) to 12” (300 mm). It is equally effective on steel, copper and PVC plastic pipe. Cal-Ban™ uses a complex electronic circuitry to alter the chemicals in solution so that they will not form hard precipitates. Electronic de-scaling is especially effective in the prevention of calcite and barium sulfate scale. Cal-Ban™ exerts a dynamic force on the moving ions that cause scaling sufficient to free them from the electrostatic bond with the water molecules. The particles of water are subjected to a current that causes the polarity of the ions to change and has the effect of raising the natural surface charge of the micro particles in the water. This electrical field causes a crystallization process to happen, and the ions to become artificially saturated. Because of the difference in polarity the micro particles stick to each other, not to pipe and vessel surfaces, forming larger particles. The crystals formed are stable for up to 5 days.

Manufactured By

WATERSOL INC.
4024 Vardell Rd. N.W.
Calgary, Alberta
Canada T3A 0C4
E watersol@telus.net

Contact

Peter Forrest
P 403.247.3127
C 403.815.8632
E pforrest@lonkar.com